The Cross Lever is an in-line brake lever designed for use on the flat upper section of drop handlebars. By routing your existing brake cable and housing from your drop levers through the Cross Lever, you can have two sets of brake levers that allow you to control your speed from multiple hand positions.

The Cross Lever can also be used on its own: Just let the head of brake cable sit in the recess for the housing on the outside of the lever.

The Cross Lever fits onto the thicker stem clamp area of handlebars, and a hinged clamp allows for installation without needing to strip your bar tape. A barrel adjuster makes it easy to fine tune your cable tension.

Two versions are available to fit handlebars with a stem clamp area diameter of 26.0mm or 31.8mm. Additionally, the hinged clamp of a 26.0mm Cross Lever is designed in a way that also allows it to mount securely on handlebars with a 25.4mm diameter stem clamp area.

Fully CNC'd construction gives them a solid feel in the hand, and they are designed to work with any kind of brake. The Cross Lever is both a Short Pull and a Long Pull lever, depending upon the position of the adjustable pivot.

The levers come with their pivot pins in the hole closest to the handlebar. This location is for short pull brakes, like road calipers, center pull cantilever brakes, and road mechanical disk brakes. Moving the pivot pin to the outer hole makes the levers compatible with long pull brakes, like our Motolites, V-Brakes and mountain mechanical disk brakes.

Tech Info:

Ordering:

Mounts to the center flat section of drop bars

26.0 and 31.8mm clamps

Interchangeable pivot position